This detector simply needs a 24 volt power source, and in the event of an alarm a volt-free contact is triggered, giving an alarm signal back to a BMS etc.
This detector does not require an i-Zone control panel.
For use within Plant rooms and other solid floor areas.
For detection of conductive water.
Manufactured from rust proof and hard wearing ABS plastic.
Gold plated detecting pins.
Two component design – keeping head and electronic module separate.
LED & internal alarm sounder in module to give local alarm indication.
Multiple types of protection covers are available to prevent mechanical damage.
This detector simply needs a 24 volt power source, and in the event of an alarm a volt-free contact is triggered, giving an alarm signal back to a BMS etc.
This detector does not require an i-Zone control panel.
Zone detector module for connection to detecting cable
Manufactured from rust proof and hard wearing ABS plastic
LED & internal alarm sounder in module to give local alarm indication
UDIN-24 ‘Universal’ Point of use Infrared Detector
This detector simply needs a 24 volt power source, and in the event of an alarm a volt-free contact is triggered, giving an alarm signal back to a BMS etc.
This detector does not require an i-Zone control panel.
For use within Plant rooms and other solid floor areas
For the detection of oil, and all other non-conductive liquids
Manufactured from rust proof and hard wearing ABS plastic
Two component design – keeping head and electronic module separate
LED & internal alarm sounder in module to give local alarm indication
Multiple types of protection covers are available to prevent mechanical damage.
This detector simply needs a 24 volt power source, and in the event of an alarm a volt-free contact is triggered, giving an alarm signal back to a BMS etc.
This detector does not require an i-Zone control panel.
For detection of water within an overflow pipe
¾” BSP threaded connector for insertion into a tee piece
Manufactured from rust proof and hard wearing ABS plastic
For connection to i-Zone or i-Zone Touch control panels
Two component design – keeping head and electronic module separate
LED & internal alarm sounder in module to give local alarm indication
This detector simply needs a 24 volt power source, and in the event of an alarm a volt-free contact is triggered, giving an alarm signal back to a BMS etc.
This detector does not require an i-Zone control panel.
For use within Sumps, Plant rooms, & water tanks
Can be set to alarm on the rise or fall of water.
Manufactured from rust proof and hard wearing ABS plastic
Float switch held in place by sprung clip.
Two component design – keeping head and electronic module separate
LED & internal alarm sounder in module to give local alarm indication
For connection to i-Zone or i-Zone Touch control panels