Ancillaries

 

RP1/3 Repeater Panel

  • This panel is used to mimic the status of the main i-Zone panel.
  • Available in three options, to monitor 1-3 main panels.
  • Each panel is represented by a separate LED.
  • Internal 97db @ 1/m sounder.
  • Accept button to silence local alarm.
  • Made of powder coated mild steel.
  • For connection to i-Zone or i-Zone Touch control panels.

 Click here for Data Sheet

 

 

 

RP1-3
 

SWRi-5 Five Ouptput Programmable Relay pack

  • Each of the 5 relays can either be used to switch ancillary items, or as zone dedicated outputs.
  • Each relay can be programmed to trigger on an alarm from any panel zone.
  • Contact ratings SPCO 16A @ 240v AC or 24v DC.
  • Housed in an IP54 rated box.
  • For connection to i-Zone or i-Zone Touch control panels.

 Click here for Data Sheet

 

 

 

 

SWRi-5
 

SWRi-8 Eight Input/Output Relay pack

  • This relay pack allows the i-Zone range of control panels to monitor eight volt-free inputs for external equipment e.g. AC units, pumps etc.
  •  The relay pack can alternatively be used to switch eight ancillary items, or as eight zone dedicated outputs.
  • Contact ratings SPCO 16A @ 240v AC or 24v DC.
  • Housed in an IP54 rated box.
  • For connection to i-Zone or i-Zone Touch control panels.

 Click here for Data Sheet

 

SWRi-8
 

PC-1 Protection Cover

  • Provides moderate mechanical protection to ‘Aqualarm’ Point of Use detectors.
  • Made from plastic coated heavy gauge wire.
  • 4 fixing points to allow cover to be fixed to the floor surface.

 

 

PC-1
 

PC-2 Heavy Duty Protection Cover

  • Provides heavy duty mechanical protection to ‘Aqualarm’ Point of Use detectors.
  • Made from powder coated mild steel.
  • 4 fixing points to allow cover to be fixed to the floor surface.

 

PC-2
 

SB-1 Stabilising Bar

  • For use with all ‘Aqualarm’ point of use detectors.
  • Two inner holes allow the detector to be securely held upright
  • Two outer countersunk holes are provided to fix the bar to the floor slab.

 

SB-1
 

DT-1 Drip Tray

  • Purpose made for our ‘Aqualarm’ cable, & point of use detectors (supplied seperately).
  • Ideal for placing below Air Conditioning units.
  • Cantilever wall brackets allow for easy positioning.
  • Design with a movable back plate allowing the detector module to be mounted away from any water collected, and increasing the visibility of the alarm LED.
  • Made from powder coated mild steel.
  • Fitted with a 22mm drain hole.
  • NOTE - AC unit shown for illustration purposes only.

Click here for Data Sheet

Drip tray
 


 
 
 


 


 


 


 


 

Newsletter Sign Up